Instructions for Use:

1. Input Connection: Connect the input voltage within the specified range (2.7V to 5.5V) to the VIN pin.
2. Output Configuration: Adjust the output voltage using external resistors connected to the FB (feedback) pin as per the datasheet formula.
3. Inductor Selection: Choose an appropriate inductor value based on the switching frequency and load current requirements.
4. Capacitor Requirements: Use input and output capacitors with low ESR values to ensure stability and efficiency.
5. Layout Considerations: Keep the power loop area small to minimize noise and interference. Place the input capacitor close to the VIN and GND pins.
6. Thermal Management: Ensure adequate heat dissipation, especially at higher load currents, by following the recommended layout guidelines.
7. Protection Features: The device includes built-in overcurrent and thermal protection to safeguard against fault conditions.