Share:
Specifications
SKU: 7286785
93C86/93LC86 Microwire Serial EEPROM
| Parameter | Description | Value |
|---|---|---|
| Device Type | Serial EEPROM with I2C Interface | 93LC86-I/P |
| Package Type | PDIP (Plastic Dual In-line Package) | 8-pin |
| Operating Voltage | Supply Voltage Range | 2.5V to 5.5V |
| Memory Size | Memory Capacity | 1024 bits |
| Organization | Organization of Memory | 128 x 8 bits |
| Data Retention | Data Retention Time | 100 years |
| Write Cycles | Number of Write Cycles | 1,000,000 cycles |
| I2C Bus Speed | Maximum Clock Frequency | 400 kHz |
| Operating Temperature | Operating Temperature Range | -40°C to +85°C |
| Standby Current | Supply Current in Standby Mode | 1 μA (max) |
| Active Current | Supply Current during Active Operation | 3 mA (max) |
Instructions for Use:
- Power Supply: Connect the VCC pin to a supply voltage between 2.5V and 5.5V and GND to ground.
- I2C Interface: Ensure proper connection of SDA (data line) and SCL (clock line) to the I2C bus. Pull-up resistors on both lines are required.
- Address Configuration: The device address is set by the A0, A1, and A2 pins. These can be grounded or connected to VCC to configure the I2C address.
- Write Operation: Before writing data, ensure that the write enable (WREN) command is sent. After writing, a write cycle must complete before another operation starts.
- Read Operation: Initiate read commands using the appropriate I2C protocol. The data will be available on the SDA line after the correct address and read command are sent.
- Handling: Follow standard ESD precautions when handling the component to avoid damage.
For detailed timing diagrams and specific command sequences, refer to the manufacturer's datasheet.
(For reference only)Inquiry - 93LC86-I/P
