Share:
Specifications
SKU: 12508714
| Parameter | Symbol | Min | Typical | Max | Unit | Conditions |
|---|---|---|---|---|---|---|
| Blocking Voltage (Collector-Emitter) | V(BR)CEO | - | 1200 | - | V | IC = 300 A, Tc = 25°C |
| Collector-Emitter Saturation Voltage | VCE(sat) | - | 1.8 | 2.4 | V | IC = 300 A, Tc = 25°C, VGE = 15 V |
| Turn-on Delay Time | td(on) | - | 1.6 | 2.4 | μs | IC = 300 A, VGE = 15 V, RL = 100 mΩ |
| Turn-off Delay Time | td(off) | - | 1.2 | 1.8 | μs | IC = 300 A, VGE = 15 V, RL = 100 mΩ |
| Gate Charge | Qg | - | 290 | 390 | nC | IC = 300 A, VGE = 15 V, VCE = 800 V |
| Total Energy Loss (Switching) | Esw | - | 110 | 150 | mJ | IC = 300 A, VCE = 800 V, f = 1 kHz |
| Continuous Collector Current | IC | - | 300 | - | A | Tc = 25°C |
| Pulse Collector Current | ICM | - | 600 | - | A | tp = 10 ms, Tc = 25°C |
| Maximum Junction Temperature | TJ(max) | - | - | 175 | °C | - |
| Storage Temperature Range | Tstg | -55 | - | 150 | °C | - |
Instructions for Use:
Mounting and Handling:
- Ensure that the device is handled with care to avoid mechanical damage.
- Use appropriate heat sinks to manage thermal dissipation, especially during high current operations.
Electrical Connections:
- Connect the collector (C), emitter (E), and gate (G) terminals correctly.
- Use short and thick leads to minimize parasitic inductance and resistance.
Thermal Management:
- Monitor the junction temperature (TJ) to ensure it does not exceed 175°C.
- Use thermal paste between the device and the heat sink to improve thermal conductivity.
Gate Drive:
- Apply a gate-emitter voltage (VGE) of at least 15 V to ensure proper turn-on.
- Ensure the gate drive circuit can provide sufficient current to charge and discharge the gate capacitance quickly.
Overcurrent Protection:
- Implement overcurrent protection to prevent damage from excessive currents.
- Consider using a current-limiting resistor or a fast-acting fuse.
Switching Frequency:
- The device is suitable for switching frequencies up to 1 kHz. Higher frequencies may require additional attention to switching losses and thermal management.
Storage and Operation:
- Store the device in a dry environment within the temperature range of -55°C to 150°C.
- Operate the device within its specified electrical and thermal limits to ensure reliable performance.
Testing:
- Before installation, test the device to ensure it meets the specified parameters.
- Use a curve tracer or equivalent equipment to verify the blocking voltage and saturation voltage.
By following these instructions, you can ensure optimal performance and longevity of the BSM300GB120DLC.
(For reference only)Inquiry - BSM300GB120DLC
